Can anyone tell me how to connect the network cable into a bnc connector? Regarding the question of how to connect the network cable into a bnc connector, let's listen to Dongguan Dosin's engineers to give you a detailed popularization. Dosin's engineers pointed out that BNC is a video signal interface, which consists of RGB three primary color signals and five independent signal connectors for horizontal synchronization and vertical synchronization. It is mainly used to connect workstations and other systems that require high scanning frequency. How to connect the network cable to the bnc connector?
The BNC interface is the interface of the monitoring cable. First, unscrew the BNC video cable connector and take the video cable. Remember that if the cable needs to pass through the wall or through the hole, it must be threaded first. After threading, the copper core is exposed about 3mm, and the copper The core wrap is exposed about 7mm, and the copper wire of the shielding mesh is twisted into a strand. Then insert the second half of the BNC connector first, otherwise it will not be able to be inserted after the wiring is connected. This is a very simple problem, but because people only care about wiring, this step is often forgotten, which will lead to re-wiring.
First, unscrew the BNC video cable connector, take the video cable, remember that if the cable needs to pass through the wall or through the hole, it must be threaded first. The shielding mesh copper wire is twisted into a strand. Then set the second half of the BNC connector first.