T.RD8503.03 Firmware: Click here to open
T.V53.03 Manual: Click here to open
T.V53.03 Firmware: Click here to open
T.SK106A.03 Manual: Click here to open
T.SK106A.03 Firmware: Click here to open
New Version T.SK105A.03 Manual: Click here to open
New Version T.SK105A.03 Firmware: Click here to open
Note: Since the driver board model is updated frequently, the appearance and chip will be different, please refer to the actual received. If you mind this, please buy carefully.
Please note before buying:
1. This product is compatible with most models. Customers only need to confirm that the LCD screen is compatible with the following resolutions, without repeating the inquiry model. (Firmware burns the corresponding resolution)
2. This product needs to burn the firmware by yourself before it can be used. If you don't know how to burn the firmware, unfortunately, it is recommended not to buy. Thank you for your understanding.
3. This kit comes with a 2ch 8bit 30pins screen cable by default. If it is not compatible with your screen, please purchase a matching screen cable separately.
4. Be sure to use the correct power supply. If the current is too low/too high, it will fail to boot, or even burn out the chip and damage the motherboard.Power Adapter: DC 12V 3-5A
5. Please pay attention to the choice of screen voltage 3.3V/5V/12V, and change the position of the jumper cap according to different voltages.
Only supports the resolution of:
1920x1200
1920x1080
1680x1050
1680x945
1600X1200
1600x900
1400X1050
1440x900
1366x768
1280x1024
1280x854
1280x800
1280x768
1280x720
1024x768
1024x600
800x600
Burning method: to record the screen program in the USB flash disk, USB flash disk inserted into board, plug in the keypad, electricity; About after a few seconds, press the keypad lights start alternating red and green flash, flash lights began to write programs (please do not power), light in the slow flash first, after a slow flash flash, will speed up the quick flash, long after the last until the lights stop flashing light is the program written, electricity burn with USB flash disk to complete the program.
Not only USB interface can be used to upgrade programs, but also can use to play video, basically formats are supported. You can also set a boot display pictures or LOGO
After the firmware is successfully burned, you can use the remote control to debugging: menu input 1147 to enter the factory mode for debugging
Description:
Model: T.V53.03 (Update from December 25, 2019)