zBoost Wideband Omni Broadcast Indoor Antenna w/ Cable | YX052-15W

zBoost Wideband Omni Broadcast Indoor Antenna is an omnidirectional ceiling mounted dome antenna. This Part # wi-Ex zBoost YX052-15W includes 15 feet of RG-6 cable. It has a type F-Female connector and TNC-F adaptor. It is broadband antenna meaning it boosts reception on a broad range of frequencies covered by all carriers in USA and Canada.

Overview:

Indoor Broadcast Antenna. Omni ceiling mount with F-Female connector and TNC-F adaptor. Wide-band covering freq. ranges 700 MHz to 2500 MHz LTE-CEL-AWS-PCS. It provides 1 - 2 dBi Gain. Purchase includes 15 feet RG-6 coax cable (YX030-15W).

Details:

Omni-directional indoor ceiling-mount antenna with RG6 cable is compatible with all zBoost and non-zBoost cell phone signal boosters. It provides additional inside coverage for larger areas by transmitting signal in all directions.

It provides 1 to 2 dBi Gain depending upon the frequency being boosted. zBoost YX05215W is a wide-band multidirectional antenna. It is for ceiling mounting. This antenna supports both 3G and 4G cellular communications on the CEL, PCS, AWS, and LTE frequency bands.

This antenna provides additional inside coverage for larger living/ working areas by transmitting signal in all directions. It uses an F-female connector and connects to your zBoost base unit using the included F to TNC adaptor.

Includes: Ceiling-mount panel antenna with F-female connector, mounting screws, TNC-male adaptor and 15 feet RG6 cable.

Summary:

• Indoor, wall-mount directional antenna.
• For fixed installations (not for vehicles).
• Built-in ground plane (no grounding needed).
• Provides up to +2 dB Gain.

Mounting the Base Unit and Omni-Directional Antenna.

The YX052 antenna provides enhanced signal strength in all directions (omni-directional) from the antenna. The antenna should be located near the center of the area where improved signal strength is desired. The antenna requires a length of coax cable (not included) to be able to connect to the Base Unit. It is recommended to use 15 feet of RG-6 cable, Part YX030-15W.

Ceiling Mounting the Base Unit Antenna.

Once you have determined the desired location for the antenna, mount the antenna using the included hardware:

1) Drill a 3⁄4 inch diameter (19 mm.) hole in the ceiling where the antenna is to be mounted.

2) Route the RF cable and threaded mount of the antenna through the hole from the room side as shown.

3) Attach the plastic nut over the threaded section extending through the ceiling and hand-tighten the nut. Excessive force can damage the threaded mount of the antenna.

4) Connect the RF cable of the antenna to a 15 feet coax extension cable (not provided). Then, using the provided TNC-F adapter, connect the coax to the Base Unit.

Specifications: