Elecbee YS-5S5CE AC to DC 5V 1A Switching Power Supply Module 5W 5V DC Voltage Conterver

 

-Universal voltage input: AC85-265V AC

-With overload, short circuit, over temperature protection function

-Comply with safety regulations, switch operating frequency 60KHz

-Full load aging test

-High output voltage accuracy

 

 

Model		YS-5S5CE
Output characteristics	Output voltage	5V
	Rated current	1000mA
	Current range	0-1000mA
	Ripple	<110mVp-p
	Output accuracy	±2%
	Voltage regulation rate	<±1%
	Load regulation rate	±1%
	Rated power	5W
	Adjustable output range	/
	Setup, rise, hold time	200ms、50ms、30ms/220VAC
Input characteristics	Input voltage range	AC100-240V
	Input current	<0.2A
	Frequency range	47Hz-63Hz
	Effectiveness	>78%
	Start impact circuit	COLD START<30AA/230VAC
	Leakage current	<1mA/220VAC
Protection characteristics	Over power protection	150-170% rated power, automatic recoveri after fault removal
	Overvoltage protection	DC OUT >150%
	Output short circuit protection	Intermittent power interruption to eliminate short-circuit power recoveri
Over temperature protection	PWM chip node temperature>80℃ close control
Environmental parameters	Working temperature, humidity	-20℃ to +60℃@100%LOAD,+60℃LOAD:20%-90%RH
	Storage temperature and humidity	-40℃ to +105℃   10%-95%RH
Safety and EMC standards	EMI. Safety standards	MEET GB4943 EN55022-B
	Withstand voltage	I/P-O/P:2.5KVAV 1min
	Insulation resistance	I/P-O/P;500VDV/100M Ohms
Other	Dimensions (length x width x height)	51.5*23.4*16.3mm
	Weight	16g

 

Note:

 

1. All parameters are measured under the conditions of rated voltage AC220V input, rated load, environment 25℃ and humidity 70%.

2. Accuracy: including setting error, voltage adjustment rate, load adjustment rate

3. Ripple test: Connect the power supply and the load with a 30cm stranded wire, connect 0.1uF and 47uF capacitors in parallel at the load end, and measure with a 20MH oscilloscope at the load end.

4. Voltage regulation rate: under rated load conditions, the input voltage changes from low to high.

5. Load regulation rate: the measured output changes from 0% to 100% load.

6. Each channel can output the maximum current, but the total load cannot exceed the maximum output power.